Design:
The cutting-edge fin reduces significant sheer load so it is an optimally designed snow guard for a temporary peel and stick solution. Safely break apart sliding snow and ice! The SnowBreaker 3M - Peel and Stick, uses pre-attached 3M brand adhesive tape. Every order includes enough SB-190 to seal around the perimeter of the snow guards. The pointed edge reduces significant sheer load so it is an ideal peel and stick solution for a temporary method of attachment when the temperature requirements can not be met for the SB-190 adhesive attachment. The SnowBreaker 3M is pleasing to the eye, easy to install, and is very effective in preventing damage caused by the sudden release of snow and ice, all without worries of overloading your roof. No other snow guard can make this claim! As the snow and ice slides on the roof, this cost-effective product minimizes the danger by slicing the frozen precipitation into small pieces so it can safely come off the roof. The forward cutting edge and the tucked back rear support form a triangular shape that acts like a fin to split up the frozen precipitation.
Isolated Areas and Doorways: In theory, a snow guard can not hold snow and ice in an isolated area on a roof because the load of the frozen mass will extend to the unprotected area. This severely overloads the snow retention system and will cause premature release and eventual failure. The SnowBreaker is not designed to hold snow for very long so this theory can be modified by placing the SnowBreaker at a 45-degree outward angle over the desired isolated area to protect. This is a huge cost saving over conventional snow guard systems that require the entire roof area to have snow retention just to protect isolated areas. Please see the drawing for recommended placement over doorways and isolated areas. CAUTION, the SnowBreaker product may not be a total protection solution for vent pipes, chimneys and masts!
What’s Included?:
The 3M SnowBreaker includes a SnowBreaker with pre-attached tape and 1 tube of SureBond SB-190 per 50 SnowBreaker 3M's to apply a bead of adhesive around the entire perimeter. Small quantity orders have the price for the SB-190 built in so if you just order one 3m SnowBreaker you will receive a tube of sealant.
Disclaimer:
Testing shows that the 3M peel and stick method of attachment has an average rating of 234 pounds of shear strength before it releases from the panel. While the peel and stick method of attachment cures quickly and does not have long application temperature requirements, it is not nearly as strong as using screws or SB-190 glue underneath the entire base for adhesive attachment. The 3M method of attachment is viewed by us as a temporary method of attachment and should not be used in areas where the ground snow loads exceed 25 PSF.
Helpful Links: SnowBreaker Cut Sheet | Spacing Overview | Isolated Placement Guidelines | SnowBreaker Specification Sheet
Select a row below to filter reviews.
5.0